Mining Slurry Pumps
Mining operations generate abrasive, high-solids slurry from dewatering, tailings transport and open-cast pits. HET slurry submersible pumps are engineered for continuous heavy-duty mining duty where conventional pumps face rapid wear and frequent failure.
The Mining Challenge
Mine dewatering and slurry transfer involve abrasive solids, variable slurry concentration and continuous operation. Pump wear, blockage and motor failure are the most common causes of downtime in mining slurry handling.
Open-cast and underground mines often require pumps that can be submerged directly in the slurry pit, reducing installation complexity and handling difficult site conditions.
What You Are Pumping
Mining slurry typically carries abrasive mineral solids, high specific gravity and a wide range of particle sizes. Concentration and solids content vary through the duty cycle, and the slurry can be mildly to highly abrasive depending on the ore.
Why It Is Difficult
The primary challenges are abrasion wear on the impeller and casing, solids handling without clogging, and reliable motor cooling under submerged continuous duty. High-head transfer over long distances or to elevated discharge points adds further pressure demand.
The HET Solution for This Application
SSEW — Heavy Slurry Lift Submersible Pump
Why HET for This Duty
HET is an Indian manufacturer of heavy-duty slurry submersible pumps with application-based selection support. Pumps are engineered for abrasive slurry and solids handling, and performance-tested before delivery. The HET engineering team reviews your duty conditions before recommending a model.
Selection Considerations
Confirm flow, head, slurry concentration, particle size and specific gravity before selection. Material of construction, impeller type and motor rating are matched to the slurry characteristics. For high-head mining duty, the SSSEW high-head family may be more suitable — request engineering review.
Other HET Slurry Submersible Pumps
Real Mining Installations
Steel Plant Scale Pit Pumping with SSEW Slurry Pump
A steel-plant scale pit accumulated hard, abrasive mill scale and ash with intermittent heavy slugs during rolling cycles. Existing pumps choked on settled solids on restart and wore quickly from the abrasive load.
Iron Ore Slurry Transfer with SSEW Heavy Slurry Pump
An iron ore handling site needed to transfer abrasive, high-solids slurry from a sump to the processing area. Conventional dewatering pumps wore rapidly and choked on settled solids, causing repeated downtime.
Mining Slurry Pumps — Frequently Asked Questions
Which HET pump is recommended for mining slurry?
Can HET submersible pumps handle high-solids mining slurry?
Need a slurry pump for mining?
Share your flow, head and slurry characteristics — our technical team will recommend a suitable HET slurry submersible pump.